FSH6 Handheld Spectrum Analyzer with Preamplifier and Tracking Generator Option

Data Sheet:
Specification FSH3 - FSH6 (rus) (1 325 kB)
FSH3 specification - FSH6 (eng, June 2005) (2 kB)
User manual (eng) (3 870 kB)

Also available for order is a 6 Hz portable spectrum analyzer model without a tracking generator - model .06. This significantly reduces the cost of the product. ( Article number 1145.5850.06 )

The pass-through power sensor FSH-Z44 will expand the capabilities of the device in measuring strong signals. With this transmitter it is possible to measure levels up to 120W (300W unmodulated carrier). Frequency range 200 MHz - 4 GHz. The result of the measurement is the incident and reflected power values. ( Cm. FSH specification)

The absorption power sensors FSH-Z1 and FSH-Z18 have a wider frequency range. These measuring heads can measure powers up to 8 GHz (for FSH-Z1) and 18 GHz (for FSH-Z18). ( Cm. FSH specification)
Measuring attenuators (available as an option from Celtec) allow you to measure power over a very wide range.

For models with a tracking generator, the following are available:

FSH-Z3 VSWR bridge with a frequency range of 10 MHz - 6 GHz. A calibration standard (Open, Short, Load) is supplied with the VSWR bridge. You can perform spectral analysis without dismantling the VSWR bridge. When switching to spectrum analysis mode, FSH automatically detects the presence of a VSWR bridge and enters an attenuation correction factor. Bridge insertion loss - 9 dB.

FSH-Z3 VSWR bridge with a frequency range of 10 MHz - 6 GHz. A calibration standard (Open, Short, Load) is supplied with the VSWR bridge.